PCM Y6b question

[nw-modeling-list at nwhs.org]

The cab signals would have been on all the Roanoke Terminal Y6s - 2120-2180 except 2162.  I don't know if any of the higher-numbered Y-6bs had them or not, off hand.  The 2162 was the only Y-6a not assigned to Shaffers Crossing for maintenance - it was assigned to Bluefield like the 2181-2200.

EdKing
  ----- Original Message ----- 
  From: nw-modeling-list at nwhs.org 
  To: nw-modeling-list at nwhs.org 
  Sent: Monday, May 29, 2006 2:15 AM
  Subject: Re: PCM Y6b question


  In a message dated 5/28/2006 6:55:35 AM Eastern Standard Time, nw-modeling-list at nwhs.org writes:
    On most Y6's pictures I have seen, on the engineer's side there is a "box" where the running board steps up, over the front engine near where the front tube sheet would be.  This is missing on the PCM model.  What is this device and did all Y6's have them? 
  That would be the cab signal box. They were put on engines used on the Shenandoah Div. Not all of the engines had them.
  Jimmy Lisle


------------------------------------------------------------------------------


  ________________________________________
  NW-Modeling-List at nwhs.org
  To change your subscription go to
  http://list.nwhs.org/mailman/options/nw-modeling-list
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://six.pairlist.net/pipermail/nw-modeling-list/attachments/20060529/50b9d92c/attachment.htm