sound decoder ?

[NW Modeling List]

Hi Stephen,
By far and above right now  is TCS's Wow Sound Decoder! Install  it in the 
tender with either a commercial speaker enclosure or If you are handy  with 
thin plywood's build and enclosure! I recommend a bass reflex install.  In 
this way the speaker face is mounted facing the inside of the enclosure.  
Seal the edge with some RTV carefully. Done properly you will end up with a 
very  good sounding engine. It will also have the volume when needed and also 
be able  to be turned down low when not. I have 3 Y3's and Y5's done this way 
and during  our clubs holiday show you can hear them across the crowded 
room! Make sure to  pack the sides of the enclosure with cotton to keep the 
Brass from  rattling!    
Enjoy!
Ray Russell Sr.
 
 
In a message dated 10/26/2015 6:45:59 A.M. Eastern Daylight Time,  
nw-modeling-list at nwhs.org writes:

 
 
I want to install a sound  decoder in a brass N&W 0-8-0. Has anyone done 
this and what decoder  would be best for this project? 
Stephen  Rainwear




-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20151026/a9ef3a69/attachment.html>