coal load removal

[NW Modeling List]

Thanks Mike. After I pulled them out, it appears it is designed to pop up on one end if you press down on the other. A bit of sanding on the sides should help.

That said, the loads aren’t very realistic. They aren’t the worst I’ve seen, but gluing a layer of coal to the surface would help. In that case, a lifting via a magnet may help prevent rubbing any “detail” off.

Matt Goodman
Columbus, Ohio

On Jun 8, 2020, at 12:09 PM, NW Modeling List via NW-Modeling-List <nw-modeling-list at nwhs.org> wrote:

Matt,
While you have the loads out, maybe epoxy a washer under it so you can use a magnet to remove the load next time.
Mike Shockley
________________________________________
NW-Modeling-List at nwhs.org
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20200608/208adb21/attachment.html>