old Rivarossi engines and large flanges

[NW Modeling List]

Kurt, did you turn them down while still mounted on their plastic driver centers? If so, did you have any issues with the tire spinning on the center?

Matt Goodman
Columbus, Ohio, US

On Aug 21, 2020, at 12:04 PM, NW Modeling List via NW-Modeling-List <nw-modeling-list at nwhs.org> wrote:

I bought a lot of them in the 70s and 80s to convert into all the classes, I had a Unimate lathe
that I turned down the flanges. The problem with swapping them out is finding the same type of axle or modifying the 
bearing area.

Kurt Kramke

On Friday, August 21, 2020, 10:19:28 AM EDT, NW Modeling List <nw-modeling-list at nwhs.org> wrote:


Gentlemen:

Has anyone attempted to change out the Large Flange Drives on old 
Rivarossi engines like the 70's Y6b or Berkshire?
Eric Raitch
Gainesville, Va


________________________________________
NW-Modeling-List at nwhs.org <mailto:NW-Modeling-List at nwhs.org>
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list <http://list.nwhs.org/mailman/options/nw-modeling-list>
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/ <http://list.nwhs.org/pipermail/nw-modeling-list/>
________________________________________
NW-Modeling-List at nwhs.org
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20200821/981a34d5/attachment.html>