[DesignII] Version 11.06 of DESIGN II for Windows

[Lynn McGuire]

This email is to notify you that version 11.06 of DESIGN II
for Windows is now available on our website at
    www.winsim.com/download.html .

This is a release of DESIGN II for Windows.  This new
release has the following changes:
1. Removed the keyword input requirement for the Multiflash
    module
2. Fixed a flash sizing type selection issue that was
    selecting a horizontal vessel when the mist eliminator
    was specified even when a vertical vessel was specified
3. Fixed the floating point math error message to only be
    shown if there is truly a problem
4. Fixed the Controller mass flow rate vary specification
    for a feed stream
5. Removed the hydrogen test from the heat exchanger Q-T
    curve calculation
6. Modified the vapor pressure curve for DMPEG above 100 F
    which reduces the amount of DMPEG in the vapor phase
7. Modified the temperature predictor for Water in DMPEG
    which increases the amount of Water in the vapor phase
    above 100 F when DMPEG is present
8. Miscellaneous small enhancements and fixes (see release
    notes  www.winsim.com/media/relnotes.chm  )

If you are on MSS or a Program Usage Agreement, then please
download the new version.

Please note that we have a web-based tutorial for DESIGN II
for Windows at	www.winsim.com/support.html .

Please note that the Password algorithm was changed for the
11.00 release.	Your new password should have been emailed
to the contact person for your account.  If you need a new
password, please contact support at winsim.com with your serial
number for your new password if you are on MSS or a Usage
agreement.

You may testdrive the new release by downloading it (80 MB)
from our website and installing it.  Run DESIGN II for
Windows and a dialog will come up with your Computer ID and
ask you for a Serial Number and Password.  You can get a
Serial Number and Password emailed to you from
    www.winsim.com/gen2wkps.html on a 24 hour a day, 7 days a
week basis.

Our next free half day training class will be on Friday,
May 4, 2012 at our new office at 8653 FM 2759, Richmond,
Texas 77469.  There are still a couple of seats open.
Please contact admin at winsim.com for more details.

We very much appreciate the testimonials that several
customers have sent us at  www.winsim.com/testimonials.html .

You can also follow us at our new Facebook page:
    www.facebook.com/winsiminc

Sincerely,
Lynn McGuire
President
8653 FM 2759 Road
Richmond, Texas 77469
281-545-9200 Phone
281-545-8820 Fax
www.winsim.com
lmc at winsim.com
sales at winsim.com
support at winsim.com