middle siding signals

NW Mailing List nw-mailing-list at nwhs.org
Mon Apr 24 08:49:17 EDT 2017


A “G” plate is not compatible with Stop & Stay. The “G” turned a Stop & Proceed into Restricting - it just eliminated the need to stop before proceeding. Usually used when climbing hills (grades - hence the “G” and the term “Grade Signal”) where the thinking was stopping and then the risk of breaking the train in two was greater than the risk of not stopping before entering the potentially occupied block.

While Stop & Stay signals could be capable of displaying Restricting (see the Call-On signal topic), it was done under dispatcher/operator control. Grade signals with their G plate had Restricting as their most restrictive signal.

-- 
Larry Stone
lstone19 at stonejongleux.com





> On Apr 23, 2017, at 5:07 PM, NW Mailing List <nw-mailing-list at nwhs.org> wrote:
> 
> On 4/19/2017 8:26 AM, NW Mailing List wrote:
> 
>> If there is a yellow plate with the letter "G" on it below the signal head displaying "Stop and stay" on the mast
> 
> I never saw a "G" plate on a "Stop & Stay" signal, only on intermediates. You had to get permission from the dispatcher to pass a "Stop & Stay".
> 
> Jimmy Lisle
> 
> ________________________________________
> NW-Mailing-List at nwhs.org
> To change your subscription go to
> http://list.nwhs.org/mailman/options/nw-mailing-list
> Browse the NW-Mailing-List archives at
> http://list.nwhs.org/pipermail/nw-mailing-list/



More information about the NW-Mailing-List mailing list