<!DOCTYPE html>
<html>
  <head>
    <meta http-equiv="Content-Type" content="text/html; charset=UTF-8">
  </head>
  <body>
    Jim,<br>
    <br>
    As if operations are not confusing enough, they varied and evolved
    over the decade from the opening of the new Elkhorn Tunnel to the
    end of steam. So by "headed West," that would be to the Eckman Yard
    table, with or without loads, turn, then pick up loads and head
    east, if in the same time period as when the mine run is still
    dispatched from Eckman Yard.<br>
    <br>
    Regarding the North Fork Mine Run, I found this:<br>
    <br>
    Regarding your mines of interest, my info only goes back to
    post-WWII. By then, the working tipples I heard about were at
    Algoma, Gilliam, Rolfe, Ashland and Crumpler. <br>
    <br>
    The North Fork Hollow mine run was a daylight job out of Eckman
    Yard. Dispatched facing upgrade, the regular power was the 2023 with
    Cicero Sells as engineer, the senior man at Eckman. <br>
    <br>
    An Elkhorn job out of Bluefield would set off empties the night
    before on the storage tracks Elk Ridge (60 cars) and North Fork (55
    cars) adjacent to the branch line near North Fork Junction. The mine
    run could bring more empties from Eckman Yard or Byrd Yard in
    Northfork, as needed. <br>
    <br>
    The job was broken up into three round trips from the junction up
    the branch: first to Algoma up the Buzzards Creek Branch, then to
    Gilliam and Rolfe, then to Ashland and Crumpler.<br>
    <br>
    Algoma was at the end of the spur with no tail track to pull past,
    so empties were pulled off the junction-end of the storage tracks
    while backing out onto the main line, then shoved forward up the
    branch main track, then up the spur. Loads came back to Byrd Yard. <br>
    <br>
    Gilliam and Rolfe were delivered by trailing point moves from the
    main track, so empties were pulled up the branch on this trip. The
    engine backed down with loads trailing to Elk Ridge and swapped the
    loads for the remaining empties.<br>
    <br>
    Like Algoma, Ashland and Crumpler were stub-end, but the empties
    were pulled up the branch to Jones Siding, run around there, then
    shoved ahead. Ashland was delivered first, leaving the loads for
    pick up on the way back down from Crumpler.<br>
    <br>
    Crumpler, aka Zenith, was steep with five, ten-car delivery tracks
    that made it particularly tedious and dangerous. With no radios to
    stop him, the rear brakeman rode the drawhead and jerked the angle
    cock open to stop. The middle brakeman made the cut while the rear
    brakeman set brakes, watching for the next cut to get on and stop
    them. Tipplemen, called "droppers", would help set brakes. Every
    load had brakes on and if they were set out on the main track, every
    brake had to be put back on.<br>
    <br>
    Loads were usually blocked at the tipples and both east and west
    loads were set out on Elk Ridge and North Fork storage tracks, the
    main track, or in the yard upon returning to Eckman.<br>
    <br>
    The North Fork mine run became First Vivian out of Bluefield when
    Eckman closed in 1951. "V1" would leave Bluefield with a 2000 in
    reverse, a cab on the pilot, and usually ran light. Empties were
    waiting on the Elk Ridge and North Fork storage tracks and Byrd Yard
    as before, but west loads were set off in Eckman Yard and it
    returned with east loads. If it was running close on time (16 hours)
    or Bluefield was (usually) unable to take short trains, the east
    loads were set off at Flat Top Yard and it ran light on to
    Bluefield.<br>
    <br>
    Sometimes the daylight job put empties in at Algoma, but the loads
    would store there until the night job could pull them. Occasionally,
    North Fork/V1 would deliver Dan's Branch, but time-slipped.<br>
    <br>
    Non-coal work included an occasional boxcar to the company store at
    Algoma. 84 would set off refrigerator cars of meat on the North Fork
    Middle Track about 1am every Monday morning for the North Fork
    Passenger Run to spot at the Wilson, Armour and Swift packing
    plants. After the passenger run was cut off, V1 would get called
    early at 4am (usually 8am) to spot the cars.<br>
    <br>
    Grant Carpenter<br>
    <br>
    <div class="moz-cite-prefix">On 11/29/2025 6:25 PM, NW Mailing List
      wrote:<br>
    </div>
    <blockquote type="cite"
cite="mid:mailman.12604.1764464475.722595.nw-mailing-list@nwhs.org">
      <meta http-equiv="content-type" content="text/html; charset=UTF-8">
      <div dir="ltr">The Elkhorn pool run has filled both the Elk Ridge
        Storage track and the North Fork Storage track, grabbed its cab
        and headed West to turn and pick up loads.  Now, a mine run gets
        dispatched from Eckman bound for the North fork branch.  What
        class locomotive?  Did it have a cab?  Was it facing forward
        (East)?  When it arrived at North fork and signed onto the
        branch,  Would it pull all the empties from both storage tracks
        at Elk Ridge or a lesser number prior to heading further up the
        holler to Algoma?<br>
        <div>Jim Cochran</div>
      </div>
    </blockquote>
  </body>
</html>