DCC Decoder with a Class J whistle?

[NW Modeling List]

Re: DCC Decoder with a Class J whistle?All,

Soundtraxx has just announced a new TSU-1000 made especially for "Southern Railroads."  This decoder features seven whistles that can be selected; these are:

N&W Class J No. 611
N&W Class A No. 1218
Crosby 3-Chime
Lunkenheimer 3-Chime
Southern Railway Single Chime
Southern Railway 3-Chime
Tweetsie Whistle (ETW&NC No. 12)

Part No. 826121, $119.00 suggested retail.

I have not heard any of these, and do not know if this decoder is yet available.

On another note, since N&W did not operate the A and J class locos on the Shenandoah Valley line, what whistle would be appropriate for the K-2 streamlined locos?  Is it the same as used in the Class J?  I've got several old Key brass locos to work on, and I might was well put sound in them too!

Thanks for any and all suggestions.

Jim Brewer
Glenwood MD
  ----- Original Message ----- 
  From: NW Modeling List 
  To: NWHS 
  Sent: Saturday, March 14, 2009 8:10 PM
  Subject: Re: DCC Decoder with a Class J whistle?


  N&W passenger whistles on steam locomotives consisted of three tones, the lowest normally sounding around 230 cps.  The other two created what musically is referred to as a "major triad".  The tuning of all three notes could vary due to changes in the pressure of the steam passing through the whistle.  Coincidentally, the SP G4s used the same whistle.  Soundtraxx offers this whistle (as a G4) in their "large steam" Tsunami decoder.  They also offer the Frisco 1522 which is a major triad.  BWL has 611's whistle programmed into their N&W class J decoder, but the tone is very raspy compared to the real thing, and I don't know if you can buy the sound decoder separately.  I recommend the Tsunami - or if you need a little more current capacity, use Soundtraxx's DSX sound-only decoder and put some 1.5 amp power decoder in parallel to run the motor.

  Bob Folsom


  On 3/8/09 11:06 AM, "NW Modeling List" <nw-modeling-list at nwhs.org> wrote:


    Does any company make a Class J whistle that is acceptable from the factory?
    I realize that there are some programmable decoders out there, too... is that a better option?
    I have an HO  Spectrum J and a Key K2a I would like to install them in.
    Thank you for any advice....

    Mike Rector

     

----------------------------------------------------------------------------
    ________________________________________
    NW-Modeling-List at nwhs.org
    To change your subscription go to
    http://list.nwhs.org/mailman/options/nw-modeling-list
    Browse the NW-Modeling-List archives at
    http://list.nwhs.org/pipermail/nw-modeling-list/





------------------------------------------------------------------------------


  ________________________________________
  NW-Modeling-List at nwhs.org
  To change your subscription go to
  http://list.nwhs.org/mailman/options/nw-modeling-list
  Browse the NW-Modeling-List archives at
  http://list.nwhs.org/pipermail/nw-modeling-list/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://six.pairlist.net/pipermail/nw-modeling-list/attachments/20090315/f06f125d/attachment.htm>